Western Digital My Book Studio Edition II User Manual download pdf (Page 32)

MY BOOK STUDIO EDITION II

USER MANUAL

REPLACING A DRIVE – 29

6. Replace the cover plate and secure it with the thumbscrew.

Note: Do not overtighten the thumbscrew.

7. Close the cover and firmly push down until it locks into place.

8. Reconnect only the power cable to the device. Do not connect computer interface

cables.

9. The drive starts the rebuild process automatically and the LEDs cycle from bottom

to top. The RAID rebuild may take up to 12 hours depending on drive capacity

and activity, but typically will complete in 5-7 hours. Allow the RAID rebuild to

complete.

10.Once complete, the LEDs will glow steadily to indicate power-on state.

11.Connect the interface cable. The WD Drive Manager Status displays (see “WD

Drive Manager Status” on page 16).

12.Return the replacement drive following the instructions provided in the WD

knowledge base article# 1709.

Important: Do not attempt to use the device during the rebuild process.

Important: Do not disassemble the internal drive and attached assembly

components. Return the entire internal drive assembly intact to WD.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38

No comments

Western Digital My Book Studio Edition II User Manual Page 32